Hello I hope someone can help..
I am trying to install a cyberdata paging gateway on Trixbox CE 2.8.0 and have read all the post on the proper config and still no luck. All I get when dialing the extension is "Call Failed"
I have made the changes to qualify=no and nat=never
If someone can PLEASE help me I would greatly appreciate it.. (also if there are some logs I can pull that may help please direct me on how to obtain them I am only a few days into the Trixbox)
Hello Alexisvfd
On the first it's good to see what equiment you use (only the term you gife : cyberdata paging gateway
If you put that in google on the second hit you have the i think the right information
At the first did you have read the manual's and FAQ on the site off Cyberdata?
I found there this :
http://www.cyberdata.net/products/voip/legacyanalog/paginggateway...
The manual read page 20 and futher
Also this document is nice :
http://www.cyberdata.net/support/server/documentation/TrixBox_Con...
A lot of picture's what says more then word's
But If you ask for information gife the complet information you alle ready have
I hink you have after reading this you paging gateway ready for use "Mr smith, local call at line 301"
Regards
John
Thanks John,
Sorry and yes that is the correct model cyberdata gateway. I have scoured there web page and my setup is identical to how they instructed it to be setup. I have also attempted emailing them several times with no reply. Like I said the unit is setup identical to how they say to and I still get the call failure message. I posted here as a last resort after spending many hours trying to get it to work. Any other suggestions would be appreciated.. I know there must be some logs that may point me in the right direction but I am not familiar on how to pull them,,
Copyright © 2011 Fonality
Fonality and trixbox are trademarks of Fonality. Trademark Policy. Privacy Policy.
Asterisk is a trademark of Digium, Inc. Fonality and trixbox are not affiliated with, nor endorsed by Digium, Inc.
Member Since:
2009-07-04