I just got Hylafax with Trixbox 2.2 setup for inbound faxing using this and this and setup hy-email2fax using this for outbound faxing.
I have a trustfax account to test both incoming and outgoing faxes, but I can't seem to fax myself.
I keep getting emails back from HylaFAX Agent saying:
No answer from remote; too many attempts to dial
---- Transcript of session follows ----
May 18 21:52:25.13: [ 8037]: SESSION BEGIN 000000061 14165551212
May 18 21:52:25.13: [ 8037]: HylaFAX (tm) Version 4.3.3
May 18 21:52:25.13: [ 8037]: SEND FAX: JOB 6 DEST 14165551212 COMMID 000000061 DEVICE '/dev/ttyIAX' FROM 'Jason Lixfeld <jason-fax-at-lixfeld.ca>' USER exim
May 18 21:52:25.13: [ 8037]: STATE CHANGE: RUNNING -> SENDING
May 18 21:52:25.13: [ 8037]: <-- [12:AT+FCLASS=1\r]
May 18 21:52:25.13: [ 8037]: --> [2:OK]
May 18 21:52:25.14: [ 8037]: MODEM set XON/XOFF/FLUSH: input ignored, output disabled
May 18 21:52:25.14: [ 8037]: DIAL 14165551212
May 18 21:52:25.14: [ 8037]: <-- [16:ATDT14165551212\r]
May 18 21:53:11.00: [ 8037]: --> [9:NO ANSWER]
May 18 21:53:11.00: [ 8037]: SEND FAILED: JOB 6 DEST 14165551212 ERR No answer from remote
May 18 21:53:11.00: [ 8037]: SEND FAILED: JOB 6 DEST 14165551212 ERR No answer from remote; too many attempts to dial
May 18 21:53:11.00: [ 8037]: <-- [5:ATH0\r]
May 18 21:53:11.01: [ 8037]: --> [2:OK]
May 18 21:53:11.01: [ 8037]: MODEM set DTR OFF
May 18 21:53:11.01: [ 8037]: MODEM set baud rate: 0 baud (flow control unchanged)
May 18 21:53:11.01: [ 8037]: STATE CHANGE: SENDING -> MODEMWAIT (timeout 5)
May 18 21:53:11.01: [ 8037]: SESSION END
------- Unsent job status -------
Destination: 14165551212
JobID: 6
GroupID: 6
Sender: Jason Lixfeld
Mailaddr: jason-fax-at-lixfeld.ca
CommID: 000000061
Modem: any
Submitted From: localhost
Page Width: 209 (mm)
Page Length: 296 (mm)
Resolution: 196 (lpi)
Status: No answer from remote; too many attempts to dial
Dialogs: 0
Dials: 11
Calls: 12
Pages: 0
TotPages: 8
Attempts: 0
Dirnum:
It seems to me like I can't hairpin a fax for some reason, but I can dial myself using my SIP phone no problem.
Anyone know where I might look for info on, or how I might go about troubleshooting this?
Member Since:
2007-01-08