X100p card isn't working - Not detecting Line ring
Submitted by aerodesliza on Sat, 06/27/2009 - 3:30pm.
I'm using Trixbox CE 2.6.2, the trixbox server work greant until yesterday, this day when I turn on the trixbox server the Line card isn't detecting the line ring, what could be?, check what I got:
[trixbox1.localdomain ~]# ztcfg -vvv
Zaptel Version: 1.4.12.1
Echo Canceller: OSLEC
Configuration
======================
Channel map:
Channel 01: FXS Kewlstart (Default) (Slaves: 01)
1 channels to configure. <-- That sound weird
[trixbox1.localdomain ~]# zttool
OK Wildcard X100P Board 1
â â Current Alarms: No alarms.
â â Sync Source: Internally clocked
â â IRQ Misses: 0
â â Bipolar Viol: 0
â â Tx/Rx Levels: 0/ 0
â â Total/Conf/Act: 1/ 1/ 0
 
I realized that when I check
Sat, 06/27/2009 - 4:57pm
I realized that when I check the line using the zttool got this Total/Conf/Act: 1/ 1/ 0 <- (not detecting line tone), I conected a phone to the Passthru port and make a call to the line (the phone rang) the status change to Total/Conf/Act: 1/ 1/ 1 <-(detecting line tone), then the status remain like that until the system is restart but still isn't working at all. I think the card is't detecting the line voltage.
 
any idea?
Mon, 06/29/2009 - 4:12pm
any idea?
 
Try to regenerate zaptel
Mon, 06/29/2009 - 11:34pm
Try to regenerate zaptel config by genzaptelconf, ztcfg -v
You may want to swap the PCI slot of X100P and regenerate zaptel again.
 
I will try, thanks
Wed, 07/01/2009 - 9:50am
I will try, thanks
 
Doest't work, what is the
Fri, 07/03/2009 - 4:34pm
Doest't work, what is the next step that I have to try?
 
X100P,,,, oh my!
Fri, 07/03/2009 - 5:03pm
If it is an X100P, then you will keep getting different problems, issues, headaches, and frustrations.. Plus of course, loss of sleep.
I would recommend go for the real thing, Digium or Sangoma, or if you wish to save some $$$, get into OpenVox, they are Trixbox certified.
Believe me, it will save you a lot of time.
Happy 4th of July!
W
 
Thanks for the advice
Sat, 07/04/2009 - 6:46am
Thanks for the advice
 
Member Since:
2008-08-10