Hello every one..
I have a qustion ..
I have a Unicorn 6040 Voice Gateway with 4 FXO ports .
i used 2 ports for 2 PSTN lines .
One is a Plain Old Telephone Service and the other is a extension on a old Analog Panasonic PBX system .
I want the calls come from outside go to this extension on my Old pbx ..
Could any one help ?
wish to be clear .. and sorry for my bad english ..
Thanks all
wish to be clear
You may wish however you where not clear. ..You need trunks and routes.
Scott
aka "Skyking"
Hay Scott ..
First, Thanks for your replay ..
I'll say it more easy ..
I have a company ... with a Panasonic old Analog PBX (Like that http://www.suntelecommunication.com/panasonic.jpg), with more then 130 local extention .
And have a 1 POTS (Plain Old Telephone Service) .
I want to make a Advanced IVR on my company .
I have a Hanlong 4 port FXO Voice Gateway .
I need to connect the POTS line to port 1 on FXO Adapter, and i'll connect a local exention from my Panasonic PBX to port 2 .
When someone call.. port one answer the call and goto IVR menu on Trixbox .. then IVR Transfere the call to the Panasonic Extentions . that mean IVR will call Panasonic PBX First then call the local extention .
And before transfere done .. Trixbox must be sure that the other party answered the call ...
its just like IVR redirection to externall FXO Port .
I found a good solution on the forum .
i registered a new exention with dial option that dials the second fxo port then dial the local exention (http://www.trixbox.org/forums/trixbox-forums/open-discussion/ivr-...) .
Good Trick .. but if the local line is busy or not answering .. the call lost .. i am just want to be sure the other party asnwerd the call or not ..
Wish to be clear this time ..
Thanks Again
Member Since:
2009-11-27