How do I install SCSI RAID with the new TB 2.2 and I have tried the "ADVANCED" and TB keep saying that there is no hard drive on my system.
My RAID card is an Adaptec ZCR 2010S. I know that I CENTOS has driver for that card.
thanks
Rocky
 
TB 2.2 and SCSI RAID
Submitted by rocky2889 on Fri, 05/04/2007 - 9:48am.
Sorry Rocky
Fri, 05/04/2007 - 10:05pm
Sorry But unless you are using a card which is "seen" by default you are back to the tar install or using a custom ks.cfg (unless there is a dd switch for advanced).
I do not know which SCSI cards are support (just about everything is SATA raid now days)
 
is that going to be a big
Sat, 05/05/2007 - 12:26am
is that going to be a big box? - if you just want to get it loaded, and its not for 200 users, try removing the ZCR controller, and just run the drives off the straight SCSI interfaces - no RAID, then just do the procedure you seem to be doing - run advanced setup - see if it sees the drives, and let it do a software RAID.
I know it might lock up if a drive dies - but just reboot it - you will live,
or otherwise get a real scsi controller like a 2100S or 2120S - these are supported natively.
 
Member Since:
2006-12-16