Can some one recommend an high end HP ML server to install trixbox CE 2.4 or 2.6 on. System must have raid 1 support. I want to use ML350 G5 but I do not know if trixbox CE support this model.
 
trixbox CE on HP proliant ML350 G5
Submitted by netvision on Tue, 05/27/2008 - 6:42pm.
I'd stick with the DL series
Wed, 05/28/2008 - 6:43am
I'd stick with the DL series personally.
 
i would have to agree with the DL
Wed, 05/28/2008 - 8:04pm
but for noise and sanity i woudl do the ml350 route.
i installed tb 2.6.0.7 on a dl380 g3 and as far as i can tell the ml350 g5 should just work.
buy it on flee bay install and test if it goes tits up relist the thing and get your $$$$ back
 
HP ml380 G5 and trixbox
Thu, 05/29/2008 - 2:32am
thanks for your reply, I will do an test with an ml 380 g5, it supports redhat linux this should mean i can get all the drivers needed.
regards,
ivan
 
I have a problem with the
Fri, 11/21/2008 - 7:20am
I have a problem with the ML350G5. Trixbox simply will not install. Installation just stopped at a point.
Every cd i tried to check gives me errors while at the same time the same cds will install properly on any other machine i have tried on including VM. I also have changed the DVD drive to another without any results
The server runs on a intel xenon quad core and 2Gb RAM
Any ideas??
 
Trixbox on Proliant ML350 G4
Tue, 04/27/2010 - 6:29pm
Hi. I just came across your post, as I can see your question never got answered. I was wondering if you had came to a solution to your problem, if so, please help me.
I have a ML350 G4 server which I want to use for Trixbox and Samba Server. My problem is exactly like yours. Tried to install 2.8 and 2.6 without luck. As soon the installation starts loading the SCSI drivers the server freezes. The only time I was able to finish the installation was with the latest 2.8.4.BETA version of Trixbox, with lots of errors during installation, but was able to finish the installation. I have 3 Aastra 6370i endpoints, registered and capable of dialing out and reaching to them. The only difference I see now(from my previous system, home brewed box with 1.6GHz processor and 512MB RAM, worked perfectly fine) is when I dial to extension. After I type in the 3digit extension, shows Available on the screen(if the extension is available of course) and then dials the extension, on my old system(Trixbox 2.8.3) this was instantaneous without any delay, and never showed such message on the screen.
I am very skeptic to stay with the BETA version. If you manged to install IP PBX on your G5, any name, please share the knowledge. In advance, your answer is greatly appreciated.
 
Member Since:
2007-01-11