Has anyone used the Cisco CLI to configure a trunk to talk to a trixbox? I currently have a 2811 running CCME and I have a trunk configured to talk to my trixbox (PhoneBochs). According to the Trixbox status, my IAX trunk is up, but has no peers. The status output is below.
Name/Username Host Mask Port Status
CiscoSIP/ciscos 192.168.1.1 (S) 255.255.255.255 4569 Unmonitored
1 iax2 peers [0 online, 0 offline, 1 unmonitored]
My SIP phones register with the trixbox and can call amongst themselves. All of my cisco phones can call amongst themselves as well. Here is my configuration regarding the SIP trunk.
dial-peer voice 1 voip
destination-pattern 8..
voice-class codec 1
session protocol sipv2
session target ipv4:192.168.3.3
dtmf-relay rtp-nte
sip-ua
authentication username ciscosip password 7 014254570F5E
no remote-party-id
retry invite 2
retry register 10
retry options 1
timers connect 100
registrar ipv4:192.168.3.3 expires 3600
sip-server ipv4:192.168.3.3
Any help would be appreciated.
Member Since:
2009-08-10