Is there a document with up to date step-by-step instructions for installing a Digium TE122 T1 card for PRI. I know I'll need a cut sheet from the Telco, but I don't know where to enter that data or the steps I need to insure all drivers for this card are installed. Or am I worrying too much? When I plug this card into a fully installed TB, will it just magically start working? I'm sure it won't be that easy.
It's a full 23+1 channel PRI.
Any help would be much appreciated.
Thanks,
unless your telco is doing some werid stuff, if your in the US you should be okay with running setup-pstn.
the only thing you'll want to make sure is the number of digits you are sending out and the number of digits they are sending back. Some require all 10, some do 7, or in my case, someone told my telco to only send me 4 digits.
it's easy enough to edit in the inbound and outbound routes.
I just did this with a 2.8 system a few days ago so it's still fresh in my mind
Where would I change this setting, or is it done in the setup-pstn?
Copyright © 2011 Fonality
Fonality and trixbox are trademarks of Fonality. Trademark Policy. Privacy Policy.
Asterisk is a trademark of Digium, Inc. Fonality and trixbox are not affiliated with, nor endorsed by Digium, Inc.
Member Since:
2008-12-18