Hello,
I would like to know if :
1)it's necessary to have a SIP provider's account in order to link two Trixbox servers for free internal calls and teleconferencing
2) it's possible to do a remote install of Trixbox CE 2.6 ?
Regards
Bidjanga
1 - No you don't know have to use a provider to interconnect two trixbox's across any IP network
2 - It is quite difficult to remote install.
Scott
aka "Skyking"
...Asterisk's native AIX protocol to interconnect your trixboxes. But there are other options such as SIP or H.323.
Hello,
If I set up a IAX trunk between Trixbox A and Trixbox B , which IP address should I use in setting Trixbox A hotsname ( or IP adress ) ? it is Trixbox B ip address ? or that of Trixbox B ?
It seems that's what is done when IAX trunking two Elastix servers.
Regards
Bidjanga Biloa
Linux and IDirect Support Engineer
Yaounde Cameroon
cell phone : +237 99894190
hello everybody ..
I don't think its the right place to ask but , I don't know where to ask :
- it is necessary to subscribe to a sip provider to make international outbound calls ?
regards
Zur - Do not hijack a thread with a different topic. There are people subscribed to the threads for information on topics. It is inconsiderate to hijack.
You should also read the getting started guides in the wiki where you will find the answer to your question.
If you have questions after reading 'trixbox without tears' or the Sureteq guide then start a new thread with your question.
Scott
aka "Skyking"
Member Since:
2009-08-01