E1 line configuration

Hi,

On and E1 there is only a few options, that can change. So when you run Setup-sangoma just simply select E1, then when it asks about the framing and line coding the line coding will not change but the framing can be ether "NCRC4" or "CRC4" so check with the telco or try both. Then you have the clocking and this is always NORMAL when connecting to the telco. Next you have the signaling and this will always be PRI-CPE which is the first option. Then the next question you have the switch type, now on E1 you can only have "EuroISDN" or "Q.SIG"; now almost all lines are "EuroISDN" so you can almost for sure select this. Next it will ask for hardware DTMF, say yes to this option. Then next it will ask for fax detection, since you have DID's enabled which you will be routing with them rather then trying to detect if it is a fax to route then say no to this option. Then the last option is it will ask you if it is a full E1; this depends on how many channels you've ordered from the telco.

If you have any issues after this then just send http://wiki.sangoma.com/SangomaTechSupport#t1_e1 into techdesk@sangoma.com. If this needs to be done ASAP then after you send the files in call 1-905-474-1990 and select the support option then provide us with the ticket # you have; your ticket number will be sent back to you about 2mins after you send in the email to techdesk.

We have just procured an E1 line with 30 lines. + 234-09-4603130 to 094603159 from a local Telco.

The line has been provisioned via a fibre optics cable to our office and plugged into our Sangoma A102 Card.

I have ran the setup command for the sangoma card to align with the service providers configuration, and now the service provider can see me.

Can you advice me on the steps to setup the lines and make my first call.