I have a Soekris net5501 with an r1t1 card plugged into the PCI slot.
I managed to get the pri working on site all fine and dandy. However two days ago the device went a missing from lspci. I got someone onsite to power cycle the device and the card now shows up in lspci.
the r1t1 driver loads properly
ztcfg -vvv & zttool list the interface as configured, no alarms.
However asterisk will not load zaptel and it says;
Asterisk has detected a problem with your Zaptel configuration and will shutdown for your protection.
I can't find a way to debug what is going on in zaptel and at what point it is failing.
Any ideas anyone?
I do not believe the configuration is at fault here as I copied the initial configuration (it was a b*** to find the right settings for the pri) and I am usign those, also I never changed them to start with to trigger the failure.
Any suggestions are most welcome!
Mike
Member Since:
2008-01-17